4
Fig.2
Fig.3
Fig.4
STABILISERS
Stabilisers are to be used, when specified, to guarantee the structural stability of the tower.
STABILISERS
Lightly tighten the upper clamps above the sixth rung on each corner post. Position the lower clamp above the bottom rung. Ensure
the lower arm is as horizontal as possible. Position the stabilisers so that the footpads are approximately equidistant from each
other, as shown in Fig.2. Adjust the outrigger and reposition the clamps as required to make firm contact with the ground. Ensure the
clips with locking pin are in place. When in the correct position, tighten the clamps firmly.
To position the tower against a wall, do not remove the stabiliser; move parallel with the wall. (Fig.3)
To position the tower in a corner, remove the inside stabiliser and place the outside two parallel with the wall. (Fig.4)
