Metallkraft KRBS 101, Инструкция по эксплуатации

Страница: 17 / 26

Care, maintenance and overhaul/repair
KRBS 101 | Version 1.03 17
Step 6: Clean the contact surfaces and the receptacle on
the contact roller holder.
Step 7: Insert the new contact roller into the contact roller
holder
Step 8: Apply the sanding belt.
Step 9: Tighten the sanding belt (observe clearance of 7
- 10 mm) and adjust the belt run..
10.4 Troubleshooting
Tension
ATTENTION!
lf one of the following faults takes place, stop the
machine at once. Before searching for lhe mistakes,
switch off and unplug the machine. All repairs ancl
changes may only be clone by qualified ancl trained
staff.
NOTE!
Contact your neared Metallkraft dealer if you are una
-
ble to solve the problems with your machine. Please
take the following information from the machine or
from the operating manual so that we can help you in
the best possible way.
- Machine model
- Serial number of the machine
- Year of manufacture
- Exact error description
Fault Possible cause Solution
The machine doesn’t work. 1. The mains plug is not connected
to the power socket.
2. Supply cables defective.
3. Switch defective.
4. Motor defective.
1. Connect the mains plug.
2. Call a service engineer.
3. Call a service engineer.
4. Call a service engineer.
The belt is not running centrically. 1. The belt operation is not adjusted.
2. Bearing damage in the contact
roll.
1. Adjust the belt operation.
2. Remove the contact roll.
The belt contacts the housing at the
level grinding area. 1. The graphite layer is worn. 1. Replace the graphite layer.
Poor grinding result. 1. Wrong grinding belt.
2. Worn grinding belt. 1. Install the correct grinding belt.
2. Change the grinding belt.