Metallkraft 3834200, Руководство по эксплуатации

Страница: 13 / 32

Setting up
AKM-Series 220 | Version 1.07 13
Make sure that
- the power connection has the same characteristics
(voltage, mains frequency, phase position) as the
motor,
- the mains voltage of 400 V is used,
- a cable cross-section of at least 1.5 mm² is used for
the supply cable,
- the direction of rotation of the motor is correct (see
direction arrow on the motor).
- The unit must be earthed before operation so that in
the event of a malfunction or malfunction, the cur-
rent through the earthing goes the way of least resi-
stance. This reduces the risk of electric shock.
Wired grounded devices:
This device is factory equipped with a specific electrical
cable and plug to prevent the device from being
connected to an inappropriate circuit for use in an ordi-
nary power circuit.
Permanently connected devices:
In this case, the device must be connected to an eart-
hed metal, via a hard-wired wiring system.
Check motor direction of rotation:
Step 1: Check that the notching machine is switched off.
Step 2: Set the cutting gap setting to maximum ma-
nually.
Step 3: Connect the notching machine to the mains.
Step 4: Briefly switch the motor on and off again.
Step 5: Check the direction of rotation when the motor
runs out, see direction of rotation arrow.
If the motor is rotating in the wrong direction:
Step 1: When equipped with a phase inverter:
Use a screwdriver to push in the washer in the
plug and turn it by 180°.
Fig. 12: Change motor direction of rotation
Without phase inverter:
Have two phases at the electrical connection re-
placed by a qualified electrician.
Step 2: Check the direction of rotation of the motor.
WARNING!
This device is equipped with a protective conductor
and an earthing cable.
The plug may only be connected to a suitable output
that is properly installed and earthed in accordance
with local laws and regulations!
WARNING!
An unsuitable connection of the earth conductor can
result in an electric shock!
Never make any changes to the grounding plug on
the device!
Only have modifications to the grounding plug car-
ried out by qualified personnel!
ATTENTION!
Danger of collision due to incorrectly set upper and
lower knives.
- Ensure that the upper or lower knives cannot collide
when the machine is switched on for the first time.
Have the upper knives dismantled by a specialist
or have the cutting gap on the lower knives increa-
sed accordingly.
WARNING!
Make sure that the socket has the same configura-
tion as the grounding plug!
Never use an adapter between the grounding plug
and the socket!
Have modifications to the grounding plug carried out
by qualified personnel only!
ATTENTION!
An incorrect direction of motor rotation will result in a
hydraulic fault!
Set the cutting gap to maximum before commissio-
ning.