Care, maintenance and repair/ servicing
SBM-Series | Version 2.02
13
10 Care, maintenance and repair/
servicing
After maintenance, repair and cleaning work, check that
all covers and protective devices have been properly fit
-
ted to the bead bending machine and that no tools are
left inside or in the working area of the bead bending ma
-
chine
10.1 Care by cleaning
Clean the bead bending machine regularly with a soft,
damp cloth.
10.2 Lubrication schedule
Fig. 13: Lubrication points
The bead bending machine must be lubricated regularly at the points
marked in Fig.13 according to the table. If the service life of the machine
is more than 8 hours per day, it must be lubricated more often.
Note that some of the lubrication points are located in the machine
housing (2 and 3). You may need to remove the covers to get to these
points.
Tips and recommendations
Proper and correct maintenance is a prerequisite for
maximum service life, good working conditions and
machine productivity.
NOTE!
The maintenance instructions must be read carefully
before care and maintenance of the bead bending
machine. Only persons familiar with the bead ben
-
ding machine are permitted to use it
DANGER!
Danger if insufficient qualification
of persons!
Insufficiently qualified persons cannot assess the
risks associated with maintenance work on the
machine and expose themselves and other persons
to the risk of serious injury.
- Have all maintenance work carried out by qualified
personnel only.
NOTE!
The bead bending machine must be lubricated at
regular intervals to ensure efficient operation and a
long service life of the machine.
No.
Location
Interval
Lubricant
1
Lubrication
bore of the up
-
per shaft
Once a week
Grease
2
Lubrication
bore of the
lower shaft
Once a week
Grease
3
Gearbox
Once a week
Grease
4
Gearbox
Once a week
Grease
ATTENTION!
The bending rollers of the bead bending machine
must never be lubricated or oiled, as otherwise the
material could slip through and is not bent. Always
keep the bending rolls free of oil and grease. Also
make sure that the material to be bent is free of oil,
grease and dirt.
