Page of 33
18
DC STICK OPERATION
• High voltage danger from power source! Consult a qualified electrician for proper
installation of receptacle. This cutter must be Grounded while in use to protect the operator
from electrical shock.
• Do not remove grounding prong or alter the plug in any way. Use only the supplied adapter
between the welder's power cord and the power source receptacle. Make sure the POWER
switch is OFF when connecting your plasma cutter's power cord directly to a properly
grounded 120 VAC, 60 Hz, single phase, 20 amp input power supply.
1. SETTING UP THE WORK PIECE
1.1 Welding positions
There are two basic positions, for welding: Flat and Horizontal. Flat welding is generally easier,
faster, and allows for better penetration. If possible, the work piece should be positioned so that the
bead will run on a flat surface.
1.2 Preparing the Joint:
Before welding, the surface of work piece needs to be free of dirt, rust, scale, oil or paint or it will
create brittle and porous welds. If the base metal pieces to be joined are thick or heavy, it may be
necessary to bevel the edges with a metal grinder, the correct bevel should be around 60 degrees.
See following picture:
Based on different welding positions, there are different welding joints. See following images for
more information.
Содержание 200iDV
Страница 29: ...Page of 33 29 MAIN CIRCUIT CHART ...
Страница 30: ...Page of 33 30 DIAGRAM PARTS LIST ...
