Step 8
Mount the hot end to the printer and connect all the
wiring. Refer to the wiring schematics on our website for
connecting cables to the motherboard.
Insert the filament guide tube from the extruder into the top of the 3.00mm Bowden clip and push down
until the tube bottoms out. The tube should extend all the way down to the top edge of the heatsink as
shown.
Step 9
WARNING
Wiring reverse polarity can damage Voltage
Regulator. Ensure the correct polarity by matching
the coloring of wires between each plug.
Heat Sink Fan
Heater Harness
Thermistor Harness
Please refer to the wiring diagrams on the User Guides page of the Metaform website for wiring the hotend to the printer.
