Metabo KFM 18 LTX 3 RF, Руководство по эксплуатации

Страница: 8 / 12

ENGLISH en
8
adapted to the working conditions. Only operate the
machine when it is in an engaged position.
Battery pack
Charge the battery pack (12) before use.
If performance diminishes, recharge the battery
pack.
The ideal storage temperature is between 10°C and
30°C.
Li-Ion battery packs "Li-Power" have a capacity and
signal indicator (11):
- Press the button (10), the LEDs indicate the
charge level.
- If one LED is flashing, the battery pack is almost
flat and must be recharged.
Removing and inserting the battery pack
Removal: Press the battery pack release (9) button
and pull the battery pack (12) downwards.
Inserting: Slide in the battery pack (12) until it
engages.
5.3 Install parallel guide/ripping fence
See illustration on page 2.
1. Place the parallel guide/ripping fence (17) as
shown.
2. Screw knurled screw (16) into one of the
threaded holes.
3. Set the parallel guide/ripping fence (17) by
turning to the desired angle.
4. Firmly tighten the knurled screw (16).
Remove the battery pack from the machine /
pull the plug out of the socket before making
any adjustments, changing tools, carrying out
maintenance or cleaning.
Indexable inserts, holders for indexable
inserts, workpiece and chips can be hot after
work. Wear protective gloves.
Danger of crushing! Wear protective gloves.
6.1 Adjust scales (only when required)
The scales (13), (15) come with the correct settings
from the factory. However, should they be adjusted,
see chapter 8.3.
6.2 Set chamfer height
Read the set chamfer height at the graduated
scale (13) :
1. Read the set chamfer height at the graduated
scale (13). See illustration: Set chamfer height =
0.7 mm.
(The scale (15) is used for the rough orientation
during the setting process).
Change the chamfer height by turning the adjusting
ring:
2.
Push the adjusting ring (14) downwards and
turn .
The chamfer height can be set in 0.1 mm (0.004“)
steps. Each full rotation results in a change of the
chamfer height by 3.0 mm (1/8“).
Remove max. 3.0 mm per cutting operation.
Create larger chamfer heights in several
cutting operations. Do not exceed the maximum
permitted chamfer height (see chapter Technical
Specifications).
3. Carry out trial cut.
7.1 Switching On and Off
Always guide the machine with both hands.
Switch on first, then guide the accessory
towards the workpiece.
Avoid unintentional start-up of the machine:
always switch off the machine, if the plug is
pulled from the mains socket or if there was a power
cut / if the battery pack was removed from the
machine.
In continuous operation, the machine
continues running if it is forced out of your
hands. Therefore, always hold the machine with
both hands using the handles provided, stand
securely and concentrate.
Avoid the machine swirling up or taking in dust
and chips. After switching off the machine,
only place it down when the motor has come to a
standstill.
Machines with slide switch:
6. Setting
7. Use
14
12
13
0
I
4