Metabo Basic 250-24 W OF, Оригинальная инструкция по эксплуатации

Страница: 10 / 68

8
ENGLISH
A
Danger!

Prior to all servicing:

Switch Off.

Unplug.

Wait until the compressor has
come to a complete stop.

Ensure the compressor and all air
tools and accessories connected
to it are relieved from pressure.
After all servicing:

Check to see that all safety
devices are operational.

Make sure that no tools or other
parts remain on or in the
machine.
Compressor does not run:

No mains voltage.

Check cables, plug, outlet and
mains fuse.

Mains voltage too low.

Use only extension cables with
sufficient lead cross section (see
"Technical Specifications"). Avoid
using extension cable with cold
machine.

Compressor was stopped by
unplugging.

Switch compressor OFF at the
On/Off switch, then ON again.

Motor has overheated, caused by
insufficient cooling (cooling fins cov-
ered).

Remove cause for overheating
and allow to cool down for
approx. 10 minutes, then start
again.
Compressor runs but does not build
up sufficient pressure.

Check valve leaky.

Have check valve serviced by
qualified service centre.
Air tool is not supplied with sufficient
pressure.

Pressure regulator not opened wide
enough.

Open pressure regulator more.

Hose connection between compres-
sor and air tool leaky.

Check air hoses, replace defec-
tive parts if necessary.
A
Danger!

Repairs to power tools must be
carried out by qualified electricians
only!
Power tools in need of repair can be sent
to one of the adresses listed on the sec-
ond-last page.
Please attach a description of the fault to
the power tool.
The machine's packaging can be 100 %
recycled.
Worn out machines and accessories
contain considerable amounts of valua-
ble raw and plastic materials, which can
be recycled.
These instructions are printed on chlo-
rine-free bleached paper.
6. Trouble Shooting
7. Repairs
8. Environmental Protection
9. Technical Specifications
Suction capacity l/min 220
Free air delivery (volume flow rate) l/min 100
Filling rate l/min 120
Working pressure (compression end pressure) bar 8
Pressure vessel volume l 24
No. of air outlets 1
No. of cylinders 1
Motor speed min
-1
2850
Motor capacity kW 1.5
Supply voltage (50 Hz) V 230
Rated current A 6.0
Fuse protection min. A 10 (time-lag)
Degree of protection IP 20
Max. overall cable length when using extension cables:

– at 3 x 1.0 mm
2
lead cross section

– at 3 x 1.5 mm
2
lead cross section

– at 3 x 2.5 mm
2
lead cross section

m

m

m
10

25

25
Dimensions length x width x height mm 630 x 406 x 630
Weight kg 25
Sound pressure level at 1 m max. dB (A) 97 ± 3