Date:
19.11.13
Ux/14-100k
Page: A2
Manual - Appendix
Fig. a.2 shows the rear sides of transmitter(left) and receiver (right) with
connectors:
•
Signal connector SUB-D 25 (
Input: +/-15V 1M
Ω
||10pF
) and
(
Output: +/-15V 10mA
)
The housing of the SUB-D connector is connected to the aluminum case,
which is connected to the circuit GND. This should be taken into account
during the test (possible ground loops, short circuits, parasitics to GND-
plane!). The pinning is shown in Fig. a.2 and is also printed on the
housings.
The receiver is also available as 19” rack mount kit (see Fig. a.3), which
allows to integrate BNC plugs at the front (pinning: inner connector is
signal) and additional other plugs in parallel (2mm Hirschmann in the
shown case). Here, the
SD-LED
is integrated as well as the power switch.
At the rear side of the receiver, the connectors for optical input and the
power supply (6-8V, 0,5A) are placed.
Notice, that the 19” rack mount kit is not made for use inside the EMC
chamber!
The SUB-D housing
has the same
potential as the
aluminum case.
Fig. a.2: Rear side of the devices with connectors and switches
Input:
+/-15V 1MΩ || 10pF
GND
GND
GND
GND
GND
GND
GND
GND
GND
16
14
12
10
8
6
2
4
13
15
11
9
7
5
3
1
PIN 1
Output:
+/-15V max. 10mA
GND
GND
GND
GND
GND
GND
GND
GND
GND
2
4
6
8
10
12
16
14
3
1
5
7
9
11
13 15
PIN 1
Rear sides with
connectors
Your pinning is
printed on the
housing!
Fig. a.3: front side of 19" receiver with connectors
Don't use 19“ rack
mount receiver
inside the ALC!
Distributed by: Reliant EMC LLC, 3311 Lewis Ave, Signal Hill CA 90755, 4089165750, www.reliantemc.com
