MESSRING 8LE-D23, Инструкция по эксплуатации

Страница: 63 / 88

M=LIGHT Control Adjust and operate the M=LIGHT LED
8LE-D23_BA_E.docm 05.02.2019
63
/
88
5.4.3.3 Error message in
Auto-Flash Light
und
Flash Light
operating mode
Figure 55: Error message in status bar
Error cause:
I The incoming Sync signal does NOT correspond to the permissible switch-on duration of the
M=LIGHT LED at preselected intensity (
Power [µs])
.
I The set value Pulse delay [µs] does NOT correspond to the permissible pulse delay to the period of
the Sync signal.
I Wrong signal polarity set ( Sync Input) .
Consequence of the error:
I Sync switch-on processes are NOT performed, which results in bright / dark frame sequences in
the shots.
Preventing errors:

Check if the incoming Sync signal corresponds to the permitted switch-on duration of the
M=LIGHT LED at the pre-selected intensity ( Power [µs]) .

Check whether the
Invert Input
checkmark or the Sync Input Signal are set correctly.

Power [%] adapt to M=LIGHT LED in tab Auto Flash Light .

Check whether Pulse delay [µs] is smaller than the period of the Sync signal.

Adjust slide control Pulse delay [µs] on tab Auto Flash Light / Flash Light .

The input signal of the M=LIGHT LED has been adjusted.