- 23 -
U.motion KNX Server Plus, Touch
Installation Manual
Furthermore, the order of the single entries can be changed. Click on the grey ORDER-button of an entry, drag it up or
down to the desired position and drop it there to fix the entry in the new position. The new sequence is shown in the
VISUALISATION after accessing the FUNCTIONS menu again.
Further information can be found in chapter 7 of this manual.
2.4.12
V
ISUALISATION
–
L
INKS
This section allows the configuration of links. Using these objects you can create page jumps to other rooms of the
visualisation or even to external web contents (like the contents of a web server or a homepage).
Further information can be found in chapter 10 of this manual.
2.4.13
V
ISUALISATION
-
S
CENARIOS
This section allows the configuration of scenarios. With scenarios, multiple actions can be launched sequentially- if
necessary also time delayed – with only one click. Scenarios can also be started as a passive event by other objects or via
scheduling.
The order of the single scenarios can be changed by opening the configuration menu of the SCENARIOS entry and by
moving the single scenarios to the desired position through drag and drop. In EXPERT mode it is also possible to define
for each scenario if it should be visible in the VISUALISATION or not.
Further information can be found in chapter 9 of this manual.
2.4.14
V
ISUALISATION
–
C
OMPLEX OBJECTS
This section allows the configuration of so-called complex objects, in which KNX objects of the same device can be
grouped and therefore will be accessible and operable in one of the available templates (for example: thermostats, blinds,
dimming, RGB control, etc.). For more information, refer to chapter 8 of this manual.
2.4.15
A
DVANCED
F
UNCTIONS
This section permits to extend the system with functionalities that are not programmed on KNX level. The following
advanced functions are available:
LOGICS
Allows AND/OR operations on 1bit KNX-objects
CONDITIONS
Permits to compare a value of one or more objects with a fixed value and to define events,
which are launched in dependency of the comparison result
VIRTUAL OBJECTS
Permits to create virtual objects for example for saving values, for connecting passive and
active events etc.
INTEGRATORS
Permits to observe / evaluate values over a given time period; specially convenient for
evaluating energy-values
NOTIFICATIONS
Permits to send notifications (either “on screen” or via mail) in dependency of events
within the installation
CLIENTS
Permits to create relations between the devices connected to U.motion KNX Server Plus
Touch (each connected device will be shown as CLIENT) and different actions of the
software, like e.g. scenarios, VoIP actions, …
RINGTONES
Contains 20 ringtones, which can be reproduced directly on U.motion KNX Server Plus
Touch in dependence of events (for example through scenarios).
