22
In the actuator component, the Easy
switching actuator for ARGUS 180 flush-
mount/230/10 has a switchable relay out-
put and enables the switching of lighting
appliances and other loads. The Easy
switching actuator for ARGUS 180 flush-
mount/230/10 has three functions, the set-
tings for which are made on the base unit:
- Switching
With this function, the on/off switching of
the load connected to the switching actua-
tor is triggered by pressing an assigned
push-button (e.g. press push-button top/
left push-button = On and press push-but-
ton bottom/right push-button = Off).
- Timer mode
In the timer mode (corresponds to stair-
case automatic function), the switching ac-
tuator receives a signal from the ARGUS
(sensor component). As soon as it receives
this signal, it starts the selected switch-on
time, and the light is switched on. When
the switch-on time has elapsed, the light is
automatically switched off. If the switching
actuator receives another signal before the
switch-on time has elapsed, it starts the
switch-on time again.
Actuator component
Anleitung_764194.book Seite 22 Dienstag, 15. Oktober 2002 11:21 11
23
The parameters for the switch-on time can
be set incrementally from 1 second to 24
hours on the base unit.
- Priority control
The "priority control" function is a safety
function. It locks the switching function
and the timer mode in the relevant actuator
until it is deactivated again, e.g. for con-
stant light in the staircase.
Priority on/off:
top/left push-button
Deactivate priority:
bottom/right
push-button
The sensor component, together with the
configured ARGUS 180 flush-mount,
forms the movement detector. The move-
ment detector (Easy switching actuator for
ARGUS 180 flush-mount/230/10 with AR-
GUS 180 flush-mount application module)
is designed for use indoors. It detects
movements within a range of 180° up to a
distance of 8 m. If the ARGUS detects
movements, it transmits signals cyclically
to the switching actuator (actuator compo-
nent).
Sensor component
Anleitung_764194.book Seite 23 Dienstag, 15. Oktober 2002 11:21 11
24
- Movement detection can be
switched off
To ensure that the ARGUS does not inter-
pret a light being switched off as a move-
ment, movement detection is blocked for
approx. 2 s.
- Light-dependent movement detection
With this function, movements are only de-
tected if the light has already been
switched on manually via a push-button.
The factory setting for this function is "dis-
abled". The setting is made on the base
unit under the parameter "Keep move. ap-
plica.".
- Block function
With this function, the ARGUS can be
functionally switched off.
- Adjustable cycle time
The cycle time is adjustable incrementally
from 10 s to 5 min on the base unit.
- Brightness evaluation
The ARGUS only detects movements if the
brightness threshold is not exceeded.
Anleitung_764194.book Seite 24 Dienstag, 15. Oktober 2002 11:21 11
