merrithew.com
5
Height Adjustment
The Telescopic Support (Upright) comes with Pre-drilled Holes [4]
for height adjustment to accommodate the users' needs, and can
be adjusted from 36½" (92.7
cm) to 44" (111.8
cm).
1
Loosen (unscrew) and pull out the Pop-up Pin [6].
2
Adjust Wooden Barre to the desired height.
3
Release and insert Pop-up Pin to ensure it has engaged
fully into one of the Pre-drilled Holes.
4
Tighten the Pop-up Pin.
NOTE:
Place your foot onto the Weighted Base to hold it down
prior to adjusting the height.
IT IS RECOMMENDED THAT ANY ADJUSTMENTS IN HEIGHT
BE MADE SIMULTANEOUSLY USING 2 PEOPLE.
Base Adjustment
The Weighted Base Plate [8] comes with adjustable Rubber Feet [9]
to accommodate most flooring.
Loosen (unscrew) or tighten (screw) Rubber Feet [8] as required to
assist in the leveling of your Stability Barre.
Parallel Stability Barre
™
Assembly
1
Assemble two Stability Barres as shown in the Stability
Barre Assembly.
2
To open Connector end: Loosen the Locking Pin. Lift the
Fold-Over Locking Pin. Open the Clamp and place around
the Telescopic Support (Upright).
3
Attach one end of the Connector to the Telescopic Support
(Upright) below the Pop-up Pin (as illustrated).
4
To secure Connector end: Close the Fold-Over Locking Pin
and secure by tightening.
5
Attach the other end of the Connector to the second
Stability Barre.
6
Repeat steps 2-5 above until all Connectors are attached
and the unit is fully assembled.
NOTE:
Parallel Stability Barres are sold as a kit
with all the Connectors included. If you have purchased
single 6', 8' or 12' Stability Barres and wish to join them
together, Connectors are also sold separately in pairs.
4
8
9
6
12' Parallel Stability Barre
(includes 6 connectors)
6' Parallel Stability Barre
(includes 4 connectors)
