Stability Barre
™
Owner’s Manual
4
Stability Barre
™
Assembly
12' Stability Barre Assembly
1
Attach the Telescopic Support (Upright) [7] to the Weighted
Base Plate [8] by turning clockwise until tightened.
NOTE: Make certain the Weighted Base Plate is aligned
perpendicular to the vertical hole in the Telescopic
Support to ensure proper threading when attaching
the Weighted Base Plate.
1
Repeat steps 1 and 2 from the Stability Barre Assembly (above)
2
Insert one 6' Wooden Barre [1] into the first Guide Tube [2]
allowing a minimum 3" (7.5
cm) overhang. Ensure the Metal
Plate of the Wooden Barre is always located at the bottom.
3
Insert the other end of the Wooden Barre [1] half-way
(5"/ 12.7
cm) into the center of the next Guide Tube [2]
4
Insert the next 6' Wooden Barre into the Guide Tube [2]
from previous step
5
Finally, place the other end of the Wooden Barre through the
remaining Guide Tube [2] allowing a minimum 3" (7.5
cm)
overhang.
4
Tighten the Knobs [3] clockwise to secure the Barre.
3
Insert the Wooden Barre [1] into the Guide Tubes [2]
allowing a minimum 3" (7.5 cm) overhang. Ensure the
Metal Plate of the Wooden Barre is located at the bottom.
Never extend the Metal Plate past the Guide Tubes.
NOTE:
The tips of the Knobs must be in contact with
the Metal Plate at all times when in use.
2
Insert Guide Tube [2] into Barre Upright [7]. Line up
Pre-drilled Holes [4] with Pop-up Pins [6].Tighten off
the Pop-up Pin [6] by securely screwing closed.
7
2
4
6
7
2
1
3
8
