Merloni Elettrodomestici 85510, Информация о сервисе

Страница: 17 / 20

17
QUICK REFERENCE CHART FOR FAULT DIAGNOSIS
Heater is cold Safety Cut-out operated
Thermostat or controller set too low
Heater switched off either at heater
switch, local isolator or consumer unit
Bad wiring connection
Supply failure
Reset
Adjust settings
Check and switch on
Check wiring
Check electrical supply
Poor heat output Settings on thermostat or controller.
Heating element failure
Faulty thermostat
Increase temperature settings
Check / replace
Check / replace
Two flashing
horizontal lines
appear on the Creda
Saver plug-in timer When installed for the first time or after
a prolonged period of power failure,
the CREDASAVER will lose its
settings. This is indicated by the
display (E) showing to horizontal lines Re-programme
CONNECT LED is
flashing on the
Receiver Radio communication failure Check Creda Zone
controller / reset.
Ensure that the Receiver is
correctly inserted.
Creda Zone
controller battery
indicator is on Faulty or missing batteries Check / replace
Safety cut-out
operated Clothing draped over heater
Restricted air circulation around heater
Faulty thermostat
Check and remove
obstructions