Merlin WeatherDrive MR550EVO, Инструкция по установке и эксплуатации

Страница: 16 / 24

15
Door Fully Closed
DN DN UP UP P P S S
1 1
2 2 3 3
132A2940
DN DN UP UP P P S S
1 1 2 2 3 3
132A2940
fig.1
fig.2
fig.3
BEEP
BEEP
Flash
x 1
Flash
x 2
This is an adjustable, second stop position suitable for
ventilation, pedestrian or pet access, programmed to the
Remote Control.
NOTE: Wireless Wall buttons will not operate this feature.
To Activate this feature:
1.Start with the door fully CLOSED (figure 1). Drive the
opener UP and stop at the position required for PET access.
2.Enter PET activation mode by pressing the P and UP
buttons together for 3 seconds (figure 2). Release when the
Courtesy light flashes once.
3.Press the Remote Control button that you have allocated for
this feature (figure 3). Do not use the button already
allocated for normal operation. The Courtesy light will flash
once when the code is accepted.
The remote will now operate to and from the “programmed” and
the “fully closed position”. Outside this range the remote will
operate as normal.
To Deactivate this feature:
1.Start with the door fully CLOSED.
2.Enter PET Activation mode by pressing the P and UP
buttons together for 3 seconds (figure 2). The Courtesy light
will flash twice, indicating that deactivation has occurred.
PARTIAL OPENING FEATURE (PET)
23
CONTROL PANEL E-LOCK (OPTIONAL)
22
DN DN UP UP PP SS
11
22 33
132A2940
Flash
x 2
BEEP
E-LOCK
or
The WeatherDrive MR550EVO has been factory set
with the Control Panel buttons UNLOCKED.
After all the Installation and programming processes are
complete, the Control Panel buttons can be locked, and
all the coded transmitters will remain active.
To Lock the Control Panel:
• Start with the door fully OPEN.
• Press and Hold both “S” and “UP” buttons for 3
seconds, while pressing a previously coded
transmitter.
• The Courtesy light will flash “TWICE”. Release all the
buttons.
The control panel is now LOCKED, and pressing any
button will only allow the courtesy light to turn ON.
Transmitters remain active.
To turn the Control panel back ON, simple repeat the
above process using any previously coded transmitter.