REMOTE CONTROL
Once the remote control has been programmed operator will operate as follows:
When gate is in the closed position, activation of the remote control button will open
the gate. During the open cycle another activation of the remote control will stop the
gate and the next activation of the remote control will close the gate.
When the gate is in the open position, activation of the remote control button will
close the gate.
OPERATION
AND MAINTENANCE
» REMOTE CONTROL
CLOSE
EDGE
OPEN
PHOTO
OPEN/EGE
PHOTO
CLOSE
PHOTO
R1
LEARN
XMITTER
L1
Ø14GPØ89ØE
Ø14LGØ89ØE
Ø14SKØ89ØE
P2
J1
J19
S1
SAVE
MAGLOCK
MODE
EDGE
PHOTO
OFF
OFF
SINGLE
NO
NO
ON
ON
DUAL
NC
NC
LEARN
XMITTER
S8
1 2 3 4
5
O
N
2
1
SWITCHED
ACCESSORY
POWER
24V
OVLD
36
INSTALLATION TIPS CONTINUED
Before powering up the MGL400-24.
• Install gate and opener in the open position.
• Disengage the opener (using the manual release) and operate gate manually to ensure gate opens and closes smoothly without any interference with mounting hardware.
• Complete full open and close cycle and ensure piston does not bottom out in either full open/close position.
• Adjust mounting hardware as necessary to eliminate interference and ensure proper piston travel.
• Repeat above steps and verify proper installation.
• Close the gate (recommended programming limits from closed position).
• Re-engage the opener (using the manual release).
• Proceed with programming limits.
• Press program limit button. Open limit light flashes. Installer must program open limit first.
INSTALLATION
STEPS CONTINUED
