21
Professional setup
Professional setup is a semi-automated procedure, similar to Easy Setup, but with the
following differences:
•
Initiate by pressing P2/RADIO instead of P1/SET
•
The installer must intervene to manually operate the gates
•
The installer may set a desired slow-down position, if not there will be no slow-
down
•
The installer must intervene to manually close the gates
•
The installer may change the behaviour in response to photocells
•
If pedestrian opening is required, then the installer must set it, otherwise pedestrian
opening time is zero
NOTE
This procedure sets the gate leaf travel times based on the detection of the limits
of travel. Gate stops or limit switches must be used. Gate stops must be positioned such
that the gates rest firmly against them at each limit of travel.
CAUTION
During this procedure the gates must be attended. Movement can be stopped
at any point by pressing the RESET button. The gates must be in the midway position
before starting this procedure.
To initiate the procedure, press RESET, press P2/RADIO for 1 second while the yellow
LED is flashing.
NOTE
It may be more convenient to use a transmitter to control the process, than to press
the P1/SET and P2/RADIO buttons on the controller board. If so, learn one button for P1
(learn the button with the CH-RADIO jumper removed), and one button for P2 (learn the
button with the CH-RADIO jumper fitted).
The following steps are performed automatically:
1.
Detects whether one motor or two is fitted
2.
Checks for presence of photocells (or a jumper) on PHO terminal; e-stop (or a
jumper) on STP terminal
3.
Begins to open the M1 leaf, with a force set by the FOR trimmer.
NOTE
If the M2 leaf moves first, or if the leaf begins to close first, press RESET to
stop the movement and then reverse the motor wiring accordingly. Start this setup
procedure again.
4.
Begins to open M2 leaf 1 second after the M1 leaf.
5.
After 3 seconds of opening, gates stop moving.
6.
Closes the M2 leaf fully, closes the M1 leaf fully, stopping hard against the closed
stops (if fitted) or stopping using a limit switch.
The following steps must be performed by the installer:
7.
Press P1/SET to begin opening the M1 and M2 leaves
8.
Press P1/SET at the time where M1 slow down to 1/3 speed is required
9.
Press P2/RADIO at the time where M2 slow down to 1/3 speed is required
10.
The M1 and M2 leaves will continue to open fully, stopping hard against the open
stops (if fitted) or stopping using a limit switch.
The following steps alter the response to interruptions of any photocells. Step 11 makes
