12
◇
If your powerchair can not avoid knocked or bumped cause the
frame deform.
◇
If the frame is out of shape due to an accident.
◆
How to replace the frame?
◇
Please proceeding steps as follows if it has to replace.
The frame assembly is composed of the front cross beam and the
frame.
Replace the cross beam by following steps if there is noise or
sticking motion during operation of the powerchair.
a.
Remove the seat assembly, the shroud and the caster wheel
assembly by step 2.1 and 2.24.
b.
Use hex tools to hold the screw (1.46) and loosen the nut (1.49)
then remove the cross beam. If the cross beam is worn out or
deformed. (See next page)
Check the whole body assembly by the following steps if there is
noise or sticking motion during operation of the powerchair.
a.
In addition to follow preceding step above, it has to remove the
footplate assembly and the anti-tipper assembly by step 2.1,
2.2.1, 2.2.2 and 2.2.3 previously.
b.
Use hex tools to loosen six pieces the screw (5.60 and 5.61) to
remove motor and gearbox assembly. (See page 11)
c.
Loosen the nut (1.79) first. Hold the screw (1.73) and loosen
the nut (1.76) to remove the rear articulating beam assembly
(L/R).
d.
Hold the screw (1.08) and loosen the nut (1.10) to remove the
freewheel release lever assembly (L/R).
e.
Hold the screw (1.24) and loosen the nut (1.25) to remove the
