COPYRIGHT © 2008 MERIT ENTERTAINMENT
HARD DRIVE
RIBBON CABLE
HARD DRIVE
POWER CONNECTOR
SCREWS SECURING
HARD DRIVE TO
MOUNTING PLATE
(4 PLACES)
SCREWS SECURING
HARD DRIVE
TO PROCESSOR
FIGURE 6 - TOP VIEW OF PROCESSOR WITH COVER REMOVED
VIBE Games
Hard Drive Removal
1.
If you are connected to TournaMAXX
or TournaCHAMP, you must perform an
Update From Server
before remov-
ing the hard drive so that no informa-
tion is deleted.
2.
Turn off and unplug the game.
3.
Unlock the lock on the processor cover
and loosen the 3 screws on either side
of the cover. Slide the cover away
from the connector side of the proces-
sor and lift the cover off of the unit.
4.
Remove the 3 screws securing the hard
drive to the processor (see Figure 6).
5.
Disconnect the I/O and audio harness,
then remove the hard drive assembly
until you’re able to disconnect the hard
drive ribbon cable and hard drive power
connector. See Figure 6.
6.
Remove the 4 screws and shoulder
washers fastening the hard drive to
the mounting plate. See Figure 6.
Hard Drive Installation
7.
Fasten the new hard drive assembly
to the existing mounting plate with the
4 screws and washers. See Figure 1.
8.
Connect the 4-pin power connector in
the game to the mating 4-pin connector
attached to the hard drive adapter. See
Figure 1.
9.
Carefully reconnect the ribbon cable in
the game to the new hard drive as
shown in Figure 1. The red stripe on
the cable should be on the opposite
side as the power connector. You may
need to create extra slack in the cable
in order to connect it.
10. Fasten the hard drive assembly to the
processor with the 3 screws (see Fig-
ure 6).
11. Continue with
Security Key Installa-
tion
if you are installing a security key.
12. Replace the processor cover and se-
cure it with the 6 screws.
13. Plug in and turn on the game. The game
will reboot twice to configure the hard-
ware. When prompted, perform a
touchscreen calibration.
14. If you are connected to TournaMAXX
or TournaCHAMP, you must re-enter the
dial-in settings, make the initial call into
the server and then perform two
Up-
dates From Server
. Refer to the
MegaNet® manual for information.
PM0513-13 MEGATOUCH FORCE 2009 EDITION 6