COPYRIGHT © 2008 MERIT ENTERTAINMENT
FORCE eVo, eVo Wallette and
Elite Edge
Hard Drive Removal
1.
If you are connected to TournaMAXX
or TournaCHAMP, you must perform an
Update From Server
before remov-
ing the hard drive so that no informa-
tion is deleted.
2.
Turn off and unplug the game.
3.
Unlock and open the CPU section.
4.
Remove the 3 screws securing the hard
drive mounting bracket to the game (the
top screw also secures the strain re-
lief cord, so you must support the front
of the game during removal). Then re-
move the hard drive assembly until
you’re able to disconnect the hard drive
power connector and the hard drive
ribbon cable running to the
motherboard. See Figure 5.
5.
Remove the 4 screws and shoulder
washers fastening the hard drive to
the mounting plate. See Figure 5.
Hard Drive Installation
6.
Fasten the new hard drive assembly
to the existing mounting plate with the
SCREWS AND
SHOULDER
WASHERS
FASTENING
HARD DRIVE TO
MOUNTING
PLATE
(BOTH SIDES)
RIBBON
CABLE
SCREWS
FASTENING
HARD
DRIVE
MOUNTING
PLATE TO
GAME
POWER
CONNECTOR
FIGURE 5 - HARD DRIVE - SCREWS FASTENING HARD DRIVE MOUNTING PLATE
5 MEGATOUCH FORCE 2009 EDITION PM0513-13
4 screws and shoulder washers. See
Figure 1.
7.
Connect the 4-pin power connector in
the game to the mating 4-pin connector
attached to the hard drive adapter. See
Figure 1.
8.
Carefully reconnect the ribbon cable in
the game to the new hard drive as
shown in Figure 1. The red stripe on
the cable should be on the opposite
side as the power connector. You may
need to create extra slack in the cable
in order to connect it.
9.
Fasten the hard drive mounting plate to
the game with the three screws. See
Figure 5.
10. Continue with
Security Key Installa-
tion
if you are installing a security key.
11. Close and lock the CPU section.
12. Plug in and turn on the game. The game
will reboot twice to configure the hard-
ware. When prompted, perform a
touchscreen calibration.
13. If you are connected to TournaMAXX
or TournaCHAMP, you must re-enter the
dial-in settings, make the initial call into
the server and then perform two
Up-
dates From Server
. Refer to the
MegaNet® manual for information.
