8
9
ASSEMBLY
STEP 4
A
Open
hardware bag 4
.
B
Slide the
console
onto the
hand grip posts
.
C
Attach the
hand grip posts
to the
console
using 4
screws (g)
and 4
arc washers (h)
from the below the
console
.
D
Connect the
console cables
and carefully tuck
wires in mast to avoid damage. Note: do not pinch
console cable. Be sure the console cable prongs
are aligned and the ends are tightly seated into each
other.
E
Attach
console cable cover
.
F
go back and completely tighten all bolts and screws
from
steps 1-4
.
SCREW (G)
10 mm
Qty: 4
ARC WASHER (H)
12 mm
Qty: 4
HARDWARE BAG 4
CONTENTS :
SCREWS (G)
ARC WASHERS (H)
CONSOLE
HAND GRIP POST
CONSOLE
UPRIGHT MAST
CONSOLE CABLE
CONSOLE CABLE
COVER
NOTE: Be careful not to pinch any wires
while attaching the console.
ASSEMBLY
STEP 3
BOLT (B)
15 mm
Qty: 6
SPRING WASHER (C)
15 mm
Qty: 4
FLAT WASHER (D)
15 mm
Qty: 4
ARC WASHER (F)
18 mm
Qty: 2
HARDWARE BAG 3
CONTENTS :
CONSOLE CABLE
(THREAD THROUGH HOLE
IN RIGHT HAND GRIP)
BOLTS (B)
SPRING WASHERS (C)
FLAT WASHERS (D)
BOLTS (B)
ARC WASHERS (F)
CONSOLE MAST
HAND GRIP
A
Open
hardware bag 3
.
B
Insert
left hand grip
onto upright
console mast
.
C
Attach the
left hand grip
to the
console
mast
using 2
bolts (b)
, 2
spring
washers (c)
and 2
flat washers (d)
from the inside and 1
bolt (b)
and 1
arc
washer (f)
from the front.
D
Carefully thread the
console cable
through
the hole in the
right hand grip
.
E
Attach the
right hand grip
as explained
above in
steps b–c
.
NOTE: Do not completely tighten any
screws or bolts until
step 4
is complete!
NOTE: Be careful not to pinch any wires
while assembling the masts.
735TSM-Eng-MSp-OM-rev1.4.indd 8-9
9/9/09 9:48 AM
