COPYRIGHT © 1996 MERIT INDUSTRIES, INC.
2
SCORPION™ 9000 MANUAL
PM0015-0B
Unhook the light power cord from the clips
holding it in place to the back of the cabinet.
Also disconnect the main wiring harness or
harnesses that may connect between the
target and base sections. Close and lock the
control panel door.
3.
Unlock and open the target section door.
Carefully pull the target lamp power cord and
other wiring harnesses up into the target
compartment. Next, remove the large black
assembly knobs and washers. Store the
knobs outside of the target section for future
use. Carefully close and lock the target
section door. Remove all keys from the
target door lock.
4.
Locate the anti-tip bracket on the rear of the
cabinet (see Figure 7). Pull upwards on the
bracket while folding the top section down.
Make sure that the top unit is resting on the
metal support bracket and that the Velcro
latch on the target section securely aligns
with the Velcro hook on the base section.
5.
Standing at the back facing the folded down
target section, place one hand on the target
section and apply a small amount of force
forward to hold the section in place. With
your other hand, take the hinge pin that is
bent to form a handle and pull outward. (See
Figure 8.) Make sure that the hinge pin is
fully removed. Repeat the same procedure
for the other hinge pin.
6.
You are now ready to remove the target
section. Lift the target section upward slightly
and position it over the safety base hook.
Place the target section, HINGE END ONLY,
on the floor.
NOTE:
DO NOT REST THE TARGET SECTION ON HOOD
END. REST IT ON THE HINGE END ONLY. FAILURE
TO DO SO COULD DAMAGE CABLES OR
OVERHEAD DISPLAY.
Reassembly of Target to Base
1.
The reassembly of the target section is very
similar to that of disassembly. Position the
target section so that it is resting on the
metal bracket of the base. Align the hinges
of the target section with the base section
hinge pins. Install the hinge pins, locking
them into position. Refer to Figure 8.
NOTE:
YOU MAY HAVE TO LIFT THE TARGET SECTION
SLIGHTLY TO ALLOW THE HINGE PINS TO MOVE
FREELY INTO THE LOCKED POSITION.
2.
Open the base control panel door.
3.
Make sure that the hinge pins are in the
locked position. Next swing the target
section up into its upright position.
4.
Very carefully open the target section front
door. Place the large black assembly knobs
and washers into the hole that they were
removed from during disassembly. (Refer to
“Floor Model Installation”, step 3.)
5.
Locate the overhead light power cable in the
control panel section. Feed your overhead
light power cable down into the base and
reconnect it to the power supply. Also
reconnect the main harness or harnesses
that interconnect between the sections.
6.
Close all doors and reconnect the power
cord to the back of the game. Reposition the
game to the wall and reconnect the safety
chain to the wall. Plug your power cord into
the wall outlet and turn on the power.
Wall Mount Installation
Your dart game is designed for permanent mounting
to any wall constructed in accordance with standard
building codes. Installing your dart cabinet is not
difficult but the following steps must be followed.
Your game comes equipped with a mounting bracket
which attaches to the wall. The complete assembled
