COPYRIGHT © 1999 MERIT INDUSTRIES, INC.
CPU Section
The CPU section is accessible from the rear
of the unit in the countertop. The CPU
section houses the CRT, the monitor
controls, the CPU and I/O boards, the power
supply, the main harness and the “SETUP”
and “CALIBRATE” switches. The Dallas
key is located on the I/O board in the
countertop model.
Coinbox Section
The coinbox section is accessible from the
front of the unit. This section is key-locked
for security purposes. A sturdy metal box
located within this section holds all coins
deposited into the machine. Also located
within the cavity of the coin mech are 2
internal switches, ”SETUP” and
“CALIBRATE,” and the coin meter.
Pressing the “SETUP” button will bring you
to the Megatouch™ Setup screen (See
Figure 1 in the Software Section of this
manual.) See the next section for calibration
instructions.
General Care and Maintenance
NOTE: THIS GAME SHOULD ONLY BE
SERVICED BY QUALIFIED SERVICE
PERSONNEL.
CAUTION: THERE ARE HIGH VOLTAGE
PARTS IN THIS GAME. BE CAREFUL
WHEN SERVICING THE INSIDE OF THE
GAME. GAME SHOULD ALWAYS BE
UNPLUGGED BEFORE SERVICING.
Screen Calibration
The machine must be in the idle mode or
game select mode to calibrate the
touchscreen.
•
Find the “CALIBRATE” button and press
it to enter the screen calibration mode.
•
Touch the center of the first circle that
appears on the screen. Once you
release your finger, a second circle will
appear on the screen.
NOTE: YOU MUST HOLD YOUR FINGER ON THE
CIRCLE FOR APPROXIMATELY 2 SECONDS FOR THE
CALIBRATION TO BE RECOGNIZED.
Site Preparation
•
Plug the game into a grounded
electrical outlet.
•
Plug the game into a separate circuit, if
at all possible. If a separate circuit is
not available, care should be taken to
provide a clean and constant voltage.
•
Place the game on a flat, level and
stable surface.
•
Place the game in a location that does
not interfere with its proper ventilation.
•
Make sure that all fans are operating
correctly and that airflow is
unobstructed. If any fans are not
operating, it is important that they be
replaced.
•
Make sure nothing is placed on top of
the cabinet or next to the fan vents that
would inhibit the flow of air.
Game Description
The countertop model has 2 key-locked
compartments: the CPU section and the
coinbox section. The countertop is equipped
with one coin mech, with optional bill
acceptors available.
The countertop model is able to be mounted
to a surface through a clearance hole in the
base pan on the bottom of the game. To
mount the game:
1. Gain access to the base pan by
removing the PC tray from the game.
2.
Rotate the lazy susan so that you see
the screw hole through the tool
clearance and drive a screw into the
surface where you are mounting the
game.
3.
Repeat step 2 for the four remaining
holes in the lazy susan.
As an added feature on the Megatouch™
SLIM MAXX, there is a hanking tie attached
to the U-Bolt (See Figure 9 on page 15 of
the manual), on the back of the game, to
provide strain relief for the power cord. It can
also be used for any other wires that may
be routed through the U-bolt in the future.
PM0240-01 MEGATOUCH™ SLIM MAXX OWNER’S MANUAL 2
