Page
8
of
14
REFER TO DRIVE OPTION ASSEMBLY MANUALS AT THIS POINT!!!
Step 6
(Winch Installation)
After the drive option is assembled on to the auger the winch will need to be installed. To install the winch,
fasten it to the bracket welded on the underside of the first tube. Secure it to the bracket by using (3) 3/8” x 1”
hex flange bolts & nuts as shown in fig. 6.1. (If handle is not installed on the winch refer to the operator’s
manual for the winch that is provided)
Step 7
(Top Guard Installation)
Next, the top drive galvanized guards need to be assembled onto the discharge tube. Place the guards over the
top drive brackets as shown in fig. 7.1. Overlap the lower guard with the top guard as shown in fig. 7.2. Attach
the 2 guards using a total of (14) #12 x 3/4" long self tapping screws. (See fig. 7.2)
Fig. 6.1
