8
Figure 16
11. INSTALLING THE LED
LIGHT BULBS & LIGHT
FRAME
NOTE:
Before starting installation, disco-
nect the power by turning off the circuit
breaker or removing the fuse at fuse box.
Turning power off using the fan switch is
not sufficient to prevent electric shock.
Step 1.
Install the three 4W ST45-4 LED
bulbs (included). (Fig. 16)
Step 2.
Remove the decorative nut, frame
cap and plastic nut from the light kit. Place
light frame over the light kit stem, secure
with the plastic nut (rubber side on the
top) frame cap and decorative nut. Do not
overtighten. (Fig. 16)
Step 3.
Insert the 2 pull chain through the
eyelet in the shade and cap. (Fig. 16)
Note:
Make sure to leave enough space
between the fan pull chain and the bulbs
so the chain doesn't rub against any of the
bulbs.
Step 4.
Restore power and your light kit is
ready for operation.
Figure 17
Bulbs
Light frame
Plastic nut
Frame cap
Decorative nut
Pull chain
12. FAN WITHOUT LIGHT
KIT
(OPTIONAL)
1. Disassemble the switch housing from the
light kit by removing nut and washer on the
center of switch housing, you can keep the
light kit for future use.
2. While holding the swith housing under
your fan, snap together the wire connection
plug.
(Fig. 17)
3. Attach the plastic plug to the switch
housing. (Fig. 17)
4. Install the switch housing to the mounting
plate with screws provided.
Mounting plate
Wire connection
plugs
Srews
Switch housing
Plastic plug