6
7. FINISHING THE
INSTALLATION
Step 1.
Tuck connections neatly into
ceiling outlet box.
Step 2.
Slide the canopy up to hanger
bracket and place the key hole on the
canopy over the screw on the hanger
bracket, turn canopy until it locks in place
at the narrow section of the key holes.
Step 3.
Align the circular hole on canopy
with the remaining hole on the hanger
bracket, secure by tightening the two set
screws.
Note:
Adjust the canopy screws as
necessary until the canopy and canopy
cover are snug. (Fig. 12)
Warning:
Make sure tab at bottom of
hanger bracket is properly seated in
groove of hanger ball before attaching
canopy to bracket. Failure to properly seat
tab in groove could cause damage to
electrical wiring.
Figure 12
Figure 13
Outlet box
Hanger
bracket
Canopy
Canopy cover
Screws
8. ATTACHING THE FAN
BLADES
Step 1. Attach the blade to the blade
bracket using the screws and fiber
washers as shown in Figure 13. Start screw
into bracket. Repeat for the two remaining
screws.
Step 2. Tighten each screw. Make sure the
blade is straight.
Step 3. Fasten blade assembly to motor
using the screws supplied. (Fig. 13)
Screws
Blade
Blade bracket
Screws
Fiber
washers