30 or 50 amp shore electrical disconnect or the on board diesel generator. Only use
the generator at anchor or at a dock without electrical service.
5.
Double check that the DC side (right) side of the panel board, has minimal electrical
load turned on and the ship’s power is in the correct position. (Opposite to the
generate position)
6.
Turn on the dock’s discount breaker; confirm you have power to the DC side of the
panel board. Turn on vessel systems as required for use only.
7.
Manage your power loads. Not all systems can be turned on and used, as you will
trip the breaker.
Sanitary System – Vacuflush System
1.
Ensure the fresh water pump electrical switch is turned on at the main electrical
panel.
2.
Ensure the head electrical switch is turned on at the main electrical panel.
3.
The toilet system is operated using the foot pedal on the side of the bowl.
4.
Lift up to add water and push down and hold for five second to clear toilet bowl.
5.
Once all materials are clear from the bowl, lift the foot pedal to add a minimum of 2
inches of water. The water helps the toilet bowl hold a seal, as the vacuum system is
allows trying to add pressure to ensure no odors come back up from the holding
tank.
6.
The holding tank is under the metal platform within the engine room. The pump out
is located on the Starboard side deck area.
7.
Please limit the use of toilet paper! If you use the amount that you use at home, it
will clog the system. Please use the garbage can lined with a plastic bag for excess
toilet paper use. Also, no female products are to be flushed into the system.
8.
On the main electrical panel, turn on the switch that monitors the fresh water and
sanitary holding tank. If the system is reading more than 60%, please schedule a
pump out ASAP. Reaching a high level of sanitary holding may cause additional
odor.
9.
If you hear a pumping sound during the night that means one of the bowls does not
have enough water in it and the seal has been broken. Fill the bowl with water and
you may turn off the vacuum system until it is used the next time.
Frige/Freezer:
1.
The refrigerator / freeze shall remain on at all times. There is a switch on both the
DC and AC side of the main electrical panel. When at dock, make sure the shore
power switch is on.
Ice-Marker:
Located on upper deck
1.
Ensure fresh water switch is on.
2.
Ensure the icemaker switch on the AC side of the main electrical panel is on.
3.
Ensure the switch at the bottom of the ice marker – as the door is open in on.
4.
The icemaker will have ice ready within 1.5 hours.
Microwave / Convection Oven:
1.
Ensure the switch on the AC side of the main electrical panel is on.
