Chapter 2 - Installation Guide
11N Wireless USB Adapter 3
Chapter 2.
Installation Guide
2.1
Hardware Installation
There are two ways to install the Adapter:
1. Plug the Adapter directly to the USB port on your computer.
2. Connect the Adapter and your computer through the USB cable attached in package.
The promoted Found New Hardware Wizard screen will pop up when the adapter is installed
correctly.
2.2
Software Installation
2.2.1 Overview
The Adapter’s Setup Wizard will guide you through the Installation procedure for Windows XP.
The Setup Wizard will install the Mercury Wireless Client Utility (MWCU) and drivers.
When you install the hardware prior to before installing the software, the system will prompt
“Found New Hardware Wizard”, click
Cancel
, and run the Setup Wizard program on the CD-ROM.
2.2.2 For Windows 2000&XP
Note:
The Setup steps for Windows 2000 and XP are similar with each other. The following
instructions take Windows XP for example.
1. Insert the Resource CD into your CD-ROM drive, choose
Network Adapter
and open the
folder named
MW150U
. Then double-click
Setup.exe
to load the following screen.