FILL THE SOLUTION TANK (1)
TURN ON THE POWER (2)
POWER TO THE BRUSHES (3)
TO RAISE OR LOWER THE BRUSH SET (4)
POWER TO THE VACUUM SYSTEM (5)
TO RAISE OR LOWER THE SQUEEGEE (6)
Fill the solution tank with pre-mixed detergent concentrate
and water.
Follow the detergent manufacturers recommended
dilution rates and mixing procedures.
Never use the solution tank as the container for
measuring and mixing. Poorly mixed, concentrated
detergents delivered to the floor can harm finishes.
Always fill the solution tank through the molded funnel in
the machine cover. Never fill with the cover open.
Solution can spill onto the battery set.
Turn the key to the “on” position to send power to the
control panel.
Press the Brush Power Switch to send power to th e
brush motor.
Step down on the pedal (at rear right on the machine),
and then push the pedal to your left to with your foot to
lock the brushes in the “up” position.
To lower the brushes, press the pedal down again, and
slide it to the right with your foot to release the pedal,
and then gently raise the pedal to lower the brushes to
the floor.
If the brush power is “on”, the brushes will spin until they
reaches the floor, then will stop spinning.
The brushes will start spinning when you tip the triggers
to travel forward or reverse. This relay prevents the
possibility of donut holes scrubbed into the floor finish.
Press the Vacuum Power Switch to turn on the vacuum
system at the squeegee.
The squeegee on this autoscrubber is free-floating -
the weight of the chassis is enough to hold the
squeegee tight against the ground.
To raise or lower the squeegee for transport, just raise
or lower the longer squeegee arm (1) at right.
!
!
!
!
!
!
!
!
!
!
!
!
HD-30 - page 4
Getting Started
MERCURY HD-30 AUTOSCRUBBER