(14) Dry Scrub Floor Machine
Dry Scrub Floor Machine (3)
1.1 Electrical Power
This floor machine operates on a 13 amp, nominal 120 V, 60
Hz A.C. power circuit (motors may be custom wired at the
factory for 220 V, 50 Hz international operation). The amp,
hertz and voltage ratings are listed on the motor spec label
found on each floor machine. Using voltages above or below
those indicated on the spec label will damage the motor.
Always check your local voltage requirements.
1.2 Grounding Instructions
This floor machine must be grounded while in use
to protect the operator from electrical shock. This
machine is built with a 3-wire cord and a 3-prong
grounding-type plug (Figure 1) to fit a properly
grounded receptacle.
Before using this floor machine, make sure a
properly grounded, 3-hole electrical outlet is
available. If not available, as in some older facilities,
use an adapter for connecting a 3-prong plug to a
2-prong receptacle (Figure 2) to ground the outlet
chassis.
IMPORTANT:
This adaptor may not be used in
Canada.
IMPORTANT:
Never cut off the grounding prong
for use in a 2-prong outlet. By doing so, you have
cut off your protection from electrical shock.
Never assume that all 3-hole outlets are properly
grounded. Check before use.
Never assume that an adaptor connection (as in
Figure 2) is properly grounded. Check the outlet
with a ground fault interrupter device which quickly
indicates if a ground is connected. Correct a faulty
grounding before proceeding.
1.3 Extension Cords are Never Recommended
The floor machine is built with a 50-foot safety power cord which plugs directly into an
approved outlet. Use of any extension cord(s) is NEVER RECOMMENDED.
Figure 1
Figure 2
10.0 6-Quart Backpack Schematic Drawing
