Mercury CyperPix S930X, Руководство пользователя, Страница: 16 / 35

16
Set Up Mode
Using Different Metering Options
1. In the
“ Photo ”
mode, press [Menu] button.
2. Use [ ][ ][ ][ ] to select “ Metering ”, and then press [Set] button.
3. Use [ ][ ][ ][ ] to select the what you want, and then press [Set] button.
Center-weighted average Very limited range in the center of the screen
Pattern
Automatic selection of the focus area where the subject
closest to the camera is located
Average
Use this metering method when you want to exert some
control over exposure, without leaving settings totally up to
the camera.
Using the Flash
Perform the following steps to select the flash mode you want to use.
1. In the
“ Photo ”
mode, press [Set] button to select the flash mode.
2. Each press of [Set] button cycles through the flash mode settings shown below on the LCD
monitor.
3.
Record the image.
Auto The flash
Force Off The flash does not fire.
Force On The flash fires automatically as required by the lighting level.
Red-eye
reduction, Auto
The flash fires automatically as required by the lighting level,
and the flash pre-strobes before shooting to reduce red-eye
phenomenon.
NOTE
You may not be able to achieve the desired results using a flash if the subject is too close or
too far away.
„ About red-eye reduction
Using the flash to record at night or in a dimly lit room can cause red spots inside the eyes of
people who are in the image. This is caused when the light from the flash reflects off of the
retina of the eye. When red-eye reduction is selected as the flash mode, the camera performs