Mercury 92-813054A2, Руководство пользователя

Страница: 76 / 97

Section 5 - Maintenance
Page 68 90-8M0069748
eng
APRIL 2012
NOTICE
Without sufficient cooling water, the engine, the water pump, and other components will overheat and suffer damage. Provide
a sufficient supply of water to the water inlets during operation.
3. If the boat is out of the water, the engine seawater pump must be supplied with cooling water. See the
Flushing the
Seawater System
section of this manual.
4. Do not install the pressure cap. Start and operate the engine at fast idle speed between 600 and 1400 RPM. Add coolant
as necessary to maintain the coolant at the level specified previously.
IMPORTANT: When installing the pressure cap, be sure to tighten it securely to avoid coolant loss.
5. Install the pressure cap after the engine has reached normal operating temperature (with the thermostat fully open) and the
coolant level remains constant.
6. Test the engine operation. Observe the temperature gauge and check the engine for coolant leaks. If the temperature
gauge indicates high coolant temperature or coolant is leaking, stop the engine immediately and inspect for the cause.
7. After the first operation, allow the engine to cool.
8. Remove the pressure cap and add the specified coolant to the level indicated in the table.
Coolant level in expansion tank
2.0
Within 25 mm (1 in.) of the top of the filler neck
9. Install and securely tighten the pressure cap.
Corrosion Protection
General Information
Whenever two or more dissimilar metals (such as those found on this power package) are submerged in a conductive solution
such as saltwater, polluted water, or water with a high mineral content, a chemical reaction takes place causing electrical
current to flow between metals. The electrical current flow causes the metal that is most chemically active, or anodic, to erode.
This erosion is known as
galvanic corrosion
and, if it is not controlled, it will eventually cause the need for replacement of power
package components exposed to water.
To help control the effects of galvanic corrosion, Mercury power packages come with several sacrificial anodes and other
corrosion protection devices. For a more comprehensive explanation of corrosion and corrosion protection refer to the
Marine
Corrosion Protection Guide
.
IMPORTANT: Replace sacrificial anodes if eroded 50% or more. Mercury strongly recommends avoiding the use of anodes
from other manufacturers. Refer to your Mercury Diesel authorized repair facility for additional information.
Engine Corrosion Protection Components
The engine is equipped with a sacrificial anode located in the end cover of the engine aftercooler to assist in protecting the
engine and the seawater cooling system from corrosion.
Removal
1. Allow the engine to cool.
NOTICE
Failure to close the seawater inlet or seacock when removing or replacing the anode plugs can lead to water damage. Close
the seacock or remove and plug the seawater inlet hose to prevent water from entering the anode plug holes.
2. With the engine off, close the seacock, if equipped, or remove and plug the seawater inlet hose.
3. Drain the seawater system. See
Draining the Seawater System
.