Mercury 8.1S Horizon, Руководство по применению продукта

Страница: 145 / 163

Instrumentation and Controls
Page 9A-12 90-863758060 AUGUST 2006
RED
RED
DK_BLU
DK_BLU
WHT
WHT
BLK
BLK
LTBLU
LTBLU
TAN
TAN
PPL
PPL
GRY
GRY
BRN_WHT
BRN_WHT
A
B
C
D
E
F
G
H
J
K
12318
1
2
3
4
5
6
7
8
9
10
1 - Connector to boat harness
2 - Trim (Sterndrive only)
3 - Tach
4 - Key on (+)
5 - Temp
6 - Oil
7 - Ground (–)
8 - Can (+) or spare
9 - Can (–) or spare
10 - 12V (+)
Remote Control and Cables
Requirements and Recommendations
We recommend using Quicksilver remote controls, which have been specifically designed
for compatibility with our engines, and to the same high quality and performance standards.
An extensive array of Quicksilver remote controls and cables are available through the
Mercury Precision Parts Accessories Guide.
A single lever control (shift and throttle function in same lever) or a two-lever control
(separate shift and throttle levers) can be used on single station applications. Two-lever
controls are required on dual station (helm) applications.
•
Remote control must provide a cable travel (at engine end).
Remote Control Cable Travel
Function Travel [with 6.8-9 kg (15-20 lb.) load applied]
Shift 70– 80 mm (2-3/4–3-1/8 in.)
Throttle 70–80 mm (2-3/4–3-1/8 in.)
• The remote control must be set up to retract the shift cable when going into FORWARD
gear on Velvet Drive 71C and 72C in-line transmissions. On Velvet Drive 5000 and all
Hurth transmissions, shift cable actuation must be set up to achieve the desired
propeller rotation. See information in
Section 2 - Transmission and Drive Line.
!
CAUTION
Transmission failure may occur. Velvet Drive Transmission Warranty is jeopardized if the
shift lever poppet ball or spring is permanently removed, if the shift lever is repositioned
or changed in any manner or if remote control and shift cable do not position shift lever
exactly as shown.
• The remote control must be set up to fully extend the throttle cable for idle.