Mercury 454 Magnum MPI Tournament Ski, Руководство по установке

Страница: 21 / 51

Whipple Charger Installations Instructions for Mercury 454/502 Magnum Engines
Power Steering
Pulley Or Idler
Sea
Pump
Alternator
Adjusting
Set Screw
Crank Pulley
22.
(99-2002 MEFI 3) Relocate factory “Merthacode” assembly on back side of head with the
supplied steel bracket (center of plate has 2 cutouts). Use supplied 3/8” x ¾” socket head
stainless bolts and 3/8” S.S. AN washers to secure.
23.
Locate the barbed fitting on starboard side of intake manifold. Install supplied 7/32”
vacuum line to this and route to map sensor that is located on backside of front plate.
Secure with zip ties.
24.
Locate the barbed fitting on port side of intake manifold (5/32”). Install supplied 5/32”
vacuum hose and route to fuel pressure regulator barbed port. Secure with zip ties.
25.
Fill supercharger with oil to middle of knurled area on dipstick, 5W-50 synthetic engine oil.
DO NOT OVERFILL SUPERCHARGER OIL LEVEL. NOTE: The SC oil system takes a
maximum of 5.4oz of oil).
†
Make sure the SC is sitting square/flat.
†
Remove -3AN allen plug and fill SC with
WHIPPLE SC OIL ONLY!!
†
Fill to the middle of the sight glass. NOTE: The W140AX compressor takes a maximum of 5.8 fl/oz.
†
Reinstall -3AN allen plug.
†
NOTE: After running the SC, the oil level will lower due to oil filling the bearings. The proper level should be
between the bottom of the sight glass and the middle.
†
Change SC oil every 50 HOURS and only use WHIPPLE SC OIL ONLY!!
!!
CAUTION
!!
Severe damage to the compressor will occur if you overfill the supercharger front gear case.
454/502 MagnumTBI_A1R9 21