background image

Mercury Security Corporation, 

©

 2008

 SR-10A

  Doc. 10107-0017  rev. 1.02 10/2008

                     

 Page 4

WARRANTY

Mercury Security Corporation warrants that the product is free from defects in material and workmanship under
normal use and service for two years from factory shipment. Mercury Security Corporation assumes no
responsibility for products damaged by improper handling or installation. This warranty is limited to the repair or
replacement of the defective unit.
There is no expressed warranties other than set forth herein. Mercury Security Corporation does not make,
intends, nor does it authorize any agent or representative to make any other warranties, implied warranties, and
expressly excludes and disclaims all implied warranties of merchantability of fitness for a particular purpose.
Returned units are repaired or replaced from a stock of reconditioned units. Returns must be accompanied by a
return authorization number obtained from customer service, a purchase order and prepaid postage.

LIABILITY

The card readers should only be used to control exits from areas where an alternate method for exit is available.
This product is not intended for, nor is rated for operation in life-critical control applications. Mercury Security
Corporation is not liable under any circumstances for loss or damage caused by or partially caused by the
misapplication or malfunction of the product. Mercury Security Corporation's liability does not extend beyond the
purchase price of the product.

Содержание SR-10A

Страница 1: ... card into the SR 10A perform the following steps 1 Remove J2 jumper 6 Once removed the LED on the reader flashes green 2 Swipe each card to be enrolled the reader will beep two times for each good card read 3 Reinstall J2 jumper 6 after enrolling card s The LED on the reader will turn red and the reader will beep three times The reader is now ready to be used Jumper 1 Jumper 2 Jumper 3 of Digits ...

Страница 2: ... havingESD electrostaticdischarge interferingwiththeoperationofthereader thereadercasing shall be grounded This can be accomplished be tying the mounting bracket to earth ground locally e g grounded conduit The reader has a four dip switch block which must be configured All four switches must be in the OFF position When looking into the back of the reader all switches should be pushed away Reader ...

Страница 3: ...ead error A maintenance schedule should be developed base on the card reader environment dirty or clean and the usage frequency light traffic or heavy traffic Extreme case may require daily cleaning Head cleaning may be done by using disposable pre saturated magnetic head cleaning card These cards are readily obtainable from a number of sources e g Clean Team Co www cleanteam com 800 888 8830 KIC ...

Страница 4: ...anties implied warranties and expressly excludes and disclaims all implied warranties of merchantability of fitness for a particular purpose Returned units are repaired or replaced from a stock of reconditioned units Returns must be accompanied by a return authorization number obtained from customer service a purchase order and prepaid postage LIABILITY The card readers should only be used to cont...

Отзывы: