Mercury Racing VesselView, Инструкция по установке, калибровке и эксплуатации

Страница: 155 / 190

Section 8 - Installation and Wiring
Page 148 90-8M8022154 APRIL 2008
Cutting the Instrument Panel
Preparing the Mounting Location
1. Select a suitable location for the VesselView on the boat's instrument panel.
NOTE: The area behind the panel should be clear of any cables, wiring, or other hardware
that may interfere with installation. The mounting location should also provide good visibility
from the boat operator's position.
2. Disconnect the batteries powering the gauges or SmartCraft components.
3. Cut out the template located on the last page of the installation instructions.
NOTE: Always check the template cutout to the mounting holes on the VesselView before
drilling.
4. Use the template to determine the space required for mounting.
5. Prepare the mounting location surface as follows:
•
Fiberglass panels:
Apply masking tape to the area being cut to prevent cracking
the fiberglass.
•
Vinyl-covered panels:
Use a razor blade to carefully remove the vinyl from the
area being cut to avoid tearing the vinyl.
Cutting the Panel
1. After preparing the area to be cut, tape the mounting template to the panel.
2. Drill four 5.5 mm (7/32 in.) holes at the locations shown on the template for the mounting
screws.
3. Drill four 19 mm (3/4 in.) holes at the locations shown on the template and cut out the
shaded portion of the template.
NOTE: The following diagram is an example only. Use the template located at the last page
of these installation instructions.
b
bb b
a
a
a
a
27043
a - Mounting screw holes (5.5 mm [7/32 in.])
b - Cutout pilot holes (19 mm [3/4 in.])