General Technical Guide VEGA Lightbars Class 2 Siren / SPA Handy with Roof Connector
GT-0775-RAM Ind B
24/10/2018
Head Office
: Zone d’Activités « Les Gailletrous » - rue Louis Pasteur- 41260 LA CHAUSSEE SAINT VICTOR
Tel : 02 54 57 52 52
– Fax 02 54 56 80 00
SAS with capital
102. 400 € - APE (NAF) 2790 Z – SIRET 310 999 891 00040
Page 10
31946-01
6.8.
LIGHTBAR INSTALLATION
4 x H M06x16 IN A4 screws
8 x Ø6x14x1.2 IN A4 flat washers
4 x H M06 IN A4 locking nuts
Position the lightbar on the roof by inserting the neoprene wedges between the bindings and the
roof.
Adjust the horizontality of the lightbar by adjusting the levels of the fixing screws of the upper and
lower legs
Locate and mark the piercing points.
Drill the roof at the locations defined at Ø 6.5mm.
Deburr the holes.
Apply corrosion protection at the holes (product not supplied)
Apply silicone sealant (not supplied) to the holes to seal the roof passages.
Place the lightbar, equipped with its fixings on the neoprene holds, on the roof.
Insert the screws and washers.
Place the fastening plywood under the roof and screw with the washers and nuts to a torque of 3NM
(aluminum roof).
Tighten the fixing screws on the base of the lightbar to a torque of 3NM
