50mm
screws
50mm screws
50mm
screws
To ensure tolerances
are equal. Measure
centre points, 4 sides
of the floor and side
and gable panels and
mark. When
assembling, line the
marks up and this will
give equal spacings.
H A N D Y H I N T
F I X I N G M E T H O D S
Remove transportation blocks from
the bottom of each panel before
beginning assembly.
1
Remove Transportion Blocks
2
3
4
5
This building should be erected
on a firm and level base.
Floor
Fix the corners with
3 x 50mm screws as in the
diagram.
Do not secure the building
to the floor until the roof is
fitted. When roof is fitted
fix the panels to the floor
with 50mm screws in
alignment with the floor
joists
Position the panels so there are
equal gaps between floor
and cladding
Internal Panel Fixing - Primary
6
8
7
Internal Panel Fixing - Bunk Floor
1. Locate the bunk
floor on to the horizontal
framing on the rear gable and
running parallel to the horizomtal
framing on the large window
side. Fix in position using
7 x 70mm screws as in the
diagram
Bunk Floor Fixing
50mm
screws
Fix ladders with 50mm
screws, pre drill all screw
holes to avoid the timber
splitting
Fix Ladder
with 4x40mm
screws as
shown in
illustration.
Ladder
*Fix bottom to rear
gable using 40mm
screw
Fix Safety Rail to
Bunk floor and door
gable using 7x40mm
screws.
Safety Rail
Door Fixing
21 x 30mm screws
9 x 50mm screws
! Please hang the door before
erecting the building.
3 x 50mm screws
Position the rear gable onto the
floor, the frame sits on the floor with
the T&G boards overlapping. Locate
the side panel in the same manner
against the rear gable frame to
frame as in diagram
This building will distort if not erected
on a firm and level base. Square the
building to the floor, making sure the
door opens.
DO NOT SECURE THE BUILDING TO
THE FLOOR UNTIL AFTER THE
ROOF HAS BEEN FITTED.
2. Position the front gable
onto the floor, the frame sits
on the floor with the T&G
boards overlapping. Locate
the side panel in the same
manner against the rear
gable frame to frame as
in diagram
6 x 50mm screws
7 x 70mm screws
Fix bunk floor to front gable
horizontal framing using
3 x 70mm screws in
shown in diagram.
3 x 70mm screws
1.
Fix the hinges to the door
with 30mm screws ensure
the screws are located into
the door framing.
2. Position the door onto the
panel leave a 1mm
gap inbetween the door and
panel . Fix the door
to the panel with
30mm screws.
* Please ensure the
door opens and
closes freely
