P 12
Please retain product label and instructions for future reference
23
28
29
Step 22
Parts needed - No. 28 QTY 1
No. 29 QTY 1
Internally, measure around
the protruding boards and
mark onto the Long & Short
Floor Boards (No’s. 28 & 29).
Once marked, cut into the
boards to create the
corresponding notches.
*Ensure the tongue of the
long floor board (
No. 29
)
faces away from the
shorter floor board.
*Cut to fit
Step 23
Parts needed - No. 28 QTY 17
No. 29 QTY 63
Continue adding the floor boards
(No’s. 28 & 29) (
internally
) making
sure to interlock each individual
board.
*Do NOT secure the boards until
the last board has been measured
and cut.
Following the same method outlined
in the previous step measure the gap between
the bottom of the tongue (on the last
board placed) and the log board.
Using a straight edge mark out the
measurement onto the last floor
board (No’s. 28 & 29) and cut along
the length removing the excess.
**Please note:
Mark the final board
1mm under the measurement; This
will allow the timber to expand and
contract correctly.
Once all the floor boards are in
position secure each board into
position using 8x40mm screws.
***Please Note:
Ensure to screw
through each of the floor boards
into the floor bearers.
640x40mm Screws
40mm
screw
Pre drill
hole
*Cut to fit
