Mercedes-Benz SLK 2012, Руководство пользователя

Страница: 285 / 321

loaded and result in a fire. Have the cause
traced and rectified at a qualified specialist
workshop.
The fuses in your vehicle serve to close down
faulty circuits. If a fuse blows, all the compo-
nents on the circuit and their functions stop
operating.
Blown fuses must be replaced with fuses of
the same rating, which you can recognise by
the colour and fuse rating. The fuse ratings
are listed in the fuse allocation chart.
If the newly inserted fuse also blows, have the
cause traced and rectified at a qualified spe-
cialist workshop, e.g. a Mercedes-Benz
Service Centre.
!
Only use fuses that have been approved
for Mercedes-Benz vehicles and which
have the correct fuse rating for the system
concerned. Otherwise, components or sys-
tems could be damaged.
Before replacing a fuse
X
Park the vehicle and apply the electric park-
ing brake.
X
Switch off all electrical consumers.
X
Remove the key from the ignition lock.
The fuses are located in various fuse boxes:
R
fuse box in the engine compartment on the
left-hand side of the vehicle, when viewed
in the direction of travel
R
fuse box in the boot behind the partition
trim
The fuse allocation chart is located in the
vehicle tool kit (
Y
page 261) in the stowage
compartment under the boot floor.
Fuse box in the engine compartment
X
Make sure that the windscreen wipers are
turned off.
G
WARNING
Make sure that the windscreen wipers are
turned off and the key is pulled out of the igni-
tion lock before you open the cover of the fuse
box. Otherwise, the windscreen wipers and
the wiper rods above the cover could be set
in motion. This could lead to you or others
being injured by the wiper rods.
X
Open the bonnet (
Y
page 248).
X
Remove any existing moisture from the
fuse box using a dry cloth.
X
To open: open clamps : .
X
Remove fuse box cover ; forwards.
!
Make sure that no moisture can enter the
fuse box when the cover is open.
X
To close: check whether the rubber seal is
lying correctly in cover ; .
X
Insert cover ; at the rear of the fuse box
into the retainer.
X
Fold down cover ; and close clamps : .
!
The cover must be fitted properly, other-
wise moisture or dirt could impair the func-
tion of the fuses.
X
Close the bonnet (
Y
page 249).
Fuse box in the boot
The fuse box is located in the boot behind the
partition covering.
X
Open the boot lid (
Y
page 73).
282
Electrical fuses
Breakdown
assistance