located on the door drive unit on the garage
ceiling.
Familiarize yourself with the garage door drive
operating instructions, e.g. under "Program-
ming additional remote controls", before carry-
ing out the following steps.
Your vehicle must be within reach of the
garage door or gate opener drive. Make sure
that neither your vehicle nor any persons/
objects are present within the sweep of the
door or gate.
X
Turn the SmartKey to position
2
in the igni-
tion lock (
Y
page 118).
X
Get out of the vehicle.
X
Press the programming button on the door
drive unit.
Usually, you now have 30 seconds to initiate
the next step.
X
Get into the vehicle.
X
Press previously programed button
;
,
=
or
?
on the integrated garage door opener
repeatedly until the door closes.
The rolling code synchronization is then
complete.
Notes on programming the remote con-
trol
Canadian radio frequency laws require a
"break" (or interruption) of the transmission
signals after broadcasting for a few seconds.
Therefore, these signals may not last long
enough for the integrated garage door opener.
The signal is not recognized during program-
ming. Comparable with Canadian law, some
U.S. garage door openers also feature a
"break".
Proceed as follows:
R
if you live in Canada.
R
if you have difficulties programming the
garage door opener (regardless of where
you live) when following the programming
steps.
X
Press and hold one of buttons
;
to
?
on
the integrated garage door opener.
After a short time, indicator lamp
:
lights
up yellow.
X
Release the button.
Indicator lamp
:
flashes yellow.
X
Press button
B
of garage door remote con-
trol
A
for two seconds, then release it for
two seconds.
X
Press button
B
again for two seconds.
X
Repeat this sequence on button
B
of
remote control
A
until indicator lamp
:
lights up green.
When indicator lamp
:
lights up green:
programming is finished.
When indicator lamp
:
flashes green: pro-
gramming was successful. The next step is
to synchronize the rolling code.
X
Release button
B
of remote control
A
of
the garage door drive.
When indicator lamp
:
lights up red:
repeat the programming process for the cor-
responding button on the rear-view mirror.
When doing so, vary the distance between
remote control
A
and the rear-view mirror.
The required distance between remote con-
trol
A
and the integrated garage door
opener depends on the garage door drive
system. Several attempts might be neces-
sary. You should test every position for at
least 25 seconds before trying another posi-
tion.
Problems when programming
If you are experiencing problems programming
the integrated garage door opener on the rear-
view mirror, take note of the following instruc-
tions:
R
Check the transmitter frequency used by
garage door drive remote control
A
and
whether it is supported. The transmitter fre-
quency can usually be found on the back of
remote control
A
for the garage door drive.
The integrated garage door opener is com-
patible with devices that have units which
operate in the frequency range of 280 to
433 MHz.
R
Replace the batteries in garage door remote
control
A
. This increases the likelihood that
garage door remote control
A
will transmit
a strong and precise signal to the integrated
garage door opener.
R
When programming, hold remote control
A
at varying distances and angles from but-
tons
;
to
?
which you are programming.
Try various angles at a distance between
2and 8 inches (5to 20 cm) or at the same
angle but at varying distances.
R
If a further remote control
A
is available for
the same garage door drive, repeat the
same programming steps with this remote
control
A
. Before performing these steps,
236
Features
St
owage
and
feat
ur
es
