41
G55.00-3163-00
G55.00-3164-00
G55.00-3165-00
Introduction of the New Unimog Generation | Model Series 405
Distribution
Hydr
aulic com
ponents
Circuit 1 hydraulic control block
Circuit 2 hydraulic valve block
Rear hydraulic valve
Special hydraulic equipment
•
Hydraulic system, 1-circuit, 2-cell, fully proportional (code
HN2)
•
Hydraulic system, 2-circuit, 3-cell, fully proportional (code
HN4)
•
Hydraulic system, 2-circuit, 3-cell, fully proportional,
snowplow relief (code HN6)
•
Hydraulic system, 2-circuit, 4-cell, fully proportional (code
HN7)
•
Hydraulic system, 2-circuit, 4-cell, fully proportional,
snowplow relief (code HN8)
Center connections of work hydraulics (circuit II only)
The hydraulic connections of circuit II for the center imple-
ment mounting space are located on the right side of the
vehicle and are always present on vehicles with dual-circuit
hydraulics (as of code HN4 to HN8). These two connections
of circuit II (pressure and separate return line) can be used
to drive permanent consumers. As at the front of the vehicle,
the connection of the pressure line is designed as a male
connector and the connection of the return line is designed
as a socket.
– This printout will not be recorded by the update service. Status: 03 / 2013 –
