Mercedes-Benz S-Class 2020, Руководство пользователя

Страница: 79 / 621

Front passenger airbag disabled
1, 2 U, L
1 Adjust the seat cushion inclination so that the front
edge of the seat cushion is in the highest position and
the rear edge of the seat cushion is in the lowest posi‐
tion.
2 The vehicle is equipped with automatic front
passenger airbag shutoff. The PASSENGER AIR BAG
OFF indicator lamp must be lit.
X Not suitable for children in this weight category.
U Suitable for child restraint systems of the "Univer‐
sal" category in this weight category.
L Suitable for semi-universal child restraint systems
according to the table in "Recommended child
restraint systems", or if the vehicle and the seat are
listed in the child restraint system manufacturer's
vehicle model list.
UF Suitable for forward-facing child restraint systems
of the "Universal" category in this weight category.
Securing the child restraint system with the
seat belt on the rear seat
When fitting a belt-secured child restraint
system, observe the following:
O Always comply with the manufacturer's
installation and operating instructions for
the child restraint system used.
O For a child restraint system in the "Univer‐
sal" or "Semi-Universal" category, make
sure that the system has been approved for
the vehicle seat.
Observe the notes under "Suitability of
seats for attaching belt-secured child
restraint systems" (
/
page 74).
O
When using a weight category 0/0+
baby car seat and a weight category I
rearward-facing child restraint system
on a rear seat: adjust the front seat so that
the seat does not touch the child restraint
system.
O When using a weight category I forward-
facing child restraint system: remove the
head restraint from the respective seat, if
possible.
After the child restraint system has been
removed, replace the head restraints again
immediately and adjust them correctly.
O The backrest of the forward-facing child
restraint system must, as far as possible, be
resting on the seat backrest of the rear
seat.
O
If the head restraint of the child seat cannot
be fully extended when it is installed in the
vehicle, this will result in restrictions on the
maximum size setting for child restraint sys‐
tems in weight category 2 or 3.
Contact with the roof when the head
restraint is fully extended and locked in
place will not result in any restrictions on
use.
O The child restraint system must not be put
under strain between the roof and the seat
cushion and/or be fitted facing the wrong
direction. Where possible, adjust the seat
cushion inclination accordingly.
O The child restraint system must not be put
under strain by the head restraint. Adjust
the head restraints as appropriate.
76 Occupant safety