Garage door remote control
A
is not included
with the integrated garage door opener.
X
Turn the SmartKey to position 2 in the igni-
tion lock (
Y
page 125).
X
Select one of buttons
;
to
?
to control
the garage door drive.
X
To start program mode: press and hold
one of buttons
;
to
?
on the integrated
garage door opener.
The garage door opener is now in program
mode. After a short time, indicator lamp
:
lights up yellow.
Indicator lamp
:
lights up yellow as soon
as button
;
,
=
or
?
is stored for the first
time. If the selected button has already
been programed, indicator lamp
:
will only
light up yellow after ten seconds have
elapsed.
X
Release button
;
,
=
or
?
. Indicator
lamp
:
flashes yellow.
X
To program the remote control: point
garage door remote control
A
towards but-
tons
;
to
?
on the rear-view mirror at a
distance of 2 to 8 in (5 to 20 cm).
X
Press and hold button
B
on remote control
A
until indicator lamp
:
lights up green.
When indicator lamp
:
lights up green:
programming is finished.
When indicator lamp
:
flashes green: pro-
gramming was successful. The next step is
to synchronize the rolling code
(
Y
page 269).
X
Release button
B
on remote control
A
for
the garage door drive system.
If indicator lamp
:
lights up red: repeat the
programing procedure for the corresponding
button on the rear-view mirror. When doing
so, vary the distance between remote con-
trol
A
and the rear-view mirror.
The required distance between remote con-
trol
A
and the integrated garage door
opener depends on the garage door drive
system. Several attempts might be neces-
sary. You should test every position for at
least 25 seconds before trying another posi-
tion.
Synchronizing the rolling code
Pay attention to the "Important safety notes"
(
Y
page 268).
If the garage door system uses a rolling code,
you will also have to synchronize the garage
door system with the integrated garage door
opener in the rear-view mirror. To do this you
will need to use the programming button on
the door drive control panel. The programming
button may be located in different places
depending on the manufacturer. It is usually
located on the door drive unit on the garage
ceiling.
Familiarize yourself with the garage door drive
operating instructions, e.g. under "Program-
ming additional remote controls", before carry-
ing out the following steps.
Your vehicle must be within reach of the
garage door or gate opener drive. Make sure
that neither your vehicle nor any persons/
objects are present within the sweep of the
door or gate.
X
Turn the SmartKey to position 2 in the igni-
tion lock (
Y
page 125).
X
Get out of the vehicle.
X
Press the programming button on the door
drive unit.
Usually, you now have 30 seconds to initiate
the next step.
X
Get into the vehicle.
X
Press previously programed button
;
,
=
or
?
on the integrated garage door opener
repeatedly and in quick succession until the
door closes.
The rolling code synchronization is then
complete.
Notes on programming the remote con-
trol
Canadian radio frequency laws require a
"break" (or interruption) of the transmission
signals after broadcasting for a few seconds.
Therefore, these signals may not last long
enough for the integrated garage door opener.
Features
269
St
owage
and
fea
tu
res
Z