Mercedes-Benz CLK Coupe 320, Руководство оператора

Страница: 151 / 408

Control system
149
operation of certain systems. They do not
replace the owner’s and/or driver’s
responsibility to maintain the vehicle’s
operating safety. Have all required
maintenance and safety checks performed
on the vehicle. Bring the vehicle to an
authorized Mercedes-Benz Center to
address the malfunction and warning
messages.
X
Press button
è
or
ÿ
repeatedly until
the Vehicle status message memory
menu appears in the multifunction display.
If conditions have occurred causing status
messages to be recorded, the number of
messages appears in the multifunction
display.
X
Press button
j
or
k
.
The stored messages will now be displayed
in the order in which they have occurred.
For malfunction and warning messages,
see “Vehicle status messages in the
multifunction display” (
Y
page 295).
Should the vehicle’s system record any
conditions while driving, the number of
messages will reappear in the multifunction
display when the SmartKey in the starter
switch is turned to position
0 or removed
from the starter switch. With KEYLESS-GO,
the number of messages will reappear when
you turn off the engine by pressing the
KEYLESS-GO start/stop button and open the
driver’s door.
Except for high-priority messages, the vehicle
status message memory will be cleared when
you switch off the ignition.
Settings menu
Introduction
In the
Settings
menu there are two
functions: The function
To reset, press
reset button for 3 seconds.
, with which
you can reset all the settings to the original
factory settings and a collection of submenus
with which you can make individual settings
for your vehicle.
The following settings and submenus are
available in the
Settings
menu:
R
Resetting to factory settings
(
Y
page 149)
R
Submenus in the Settings menu
(
Y
page 150)
R
Instrument cluster submenu
(
Y
page 151)
R
Time/Date submenu (
Y
page 152)
R
Lighting submenu (
Y
page 153)
R
Vehicle submenu (
Y
page 155)
R
Convenience submenu (
Y
page 156)
Resetting to factory settings
You can reset the functions of all submenus
to the factory settings.
For safety reasons, the function
Headlamp
Mode
in the
Lighting
submenu cannot be
reset while driving.
X Press button
è
or
ÿ
repeatedly until
the
Settings
menu appears in the
multifunction display.
Controls in detail
Z