Mercedes-Benz CLK 63 AMG, Руководство оператора

Страница: 304 / 521

303
Controls in detail
Useful features
begins to flash after approximately
20 seconds (do not hold the button for
longer than 30 seconds). This proce-
dure erases any previous settings for
all three channels and initializes the
memory.
If you later wish to program a second
and/or third hand-held transmitter to
the remaining two signal transmitter
buttons, do not repeat this step and be-
gin directly with step 3.
Step 3:
왘
Hold the end of hand-held remote
control
5
of the device you wish to
train approximately 2 to 5 inches
(5 to12 cm) away from the signal trans-
mitter button (
2
,
3
or
4
) to be pro-
grammed, while keeping indicator
lamp
1
in view.
Step 4:
왘
Using both hands, simultaneously
press hand-held remote control
button
6
and the desired signal trans-
mitter button (
2
,
3
or
4
). Do not
release the buttons until step 5 is com-
pleted.
Indicator lamp
1
will flash, first slowly
and then rapidly.
Step 5:
왘
After indicator lamp
1
changes from a
slow to a rapidly flashing light, release
the hand-held remote control button
and the signal transmitter button.
Step 6:
왘
Press and hold the just-trained signal
transmitter button (
2
,
3
or
4
) and
observe indicator lamp
1
.
If indicator lamp
1
stays on
constantly, programming is complete
and your device should activate when
the respective signal transmitter
button (
2
,
3
or
4
) is pressed and
released.
Step 7:
왘
To program the remaining two signal
transmitter buttons, repeat the steps
above starting with step 3.
i
Indicator lamp
1
flashes immediately the
first time the signal transmitter button is pro-
grammed. If this button has already been pro-
grammed, the indicator lamp will only start
flashing after 20 seconds.
i
If indicator lamp
1
flashes rapidly for about
2 seconds and then turns to a constant light,
continue with programming steps 8 through 12
as your garage door opener may be equipped
with the “rolling code” feature.