Version 17.02.2020
HW:
FV09(V41)
CI-VL2-MBN2
P
a
g
e
5
1.3.2.
Rear-view camera settings (dip 5)
Depending on whether no camera, after-market camera or
factory camera shall be used, dip 5 must use different settings.
If set to OFF, the interface switches to factory picture when the
reverse gear is engaged to display factory rear-view camera or
factory PDC picture.
2.
Installation
Switch off ignition and disconnect the vehicle’s battery! The interface needs a permanent
12V source. If according to factory rules disconnecting the battery is to be avoided, it is
usually sufficient to put the vehicle is sleep-mode. In case the sleep-mode does not show
success, disconnect the battery with a resistor lead.
If power source is not taken directly from the battery, the connection has to be checked
for being start-up proven and permanent.
2.1.
Installationsort
The interface is installed on the backside of the monitor panel. Therefore, the head-unit
must be removed.
Remove head-unit.
Remove the upper cover including the DVD/
navigation device. The external daughter PCB
is plugged in between the flex cable of the
monitor panel and the mainboard of the head-unit.
Rear-view
camera type
Dip 5
None
OFF
Factory
OFF
After-market
ON