Mercedes-Benz AMG GT, Руководство оператора

Страница: 331 / 450

#
Remove the hub caps if necessary
(
/
page 329).
#
Raise the vehicle (
/
page 329).
Removing and installing the wheel trim/hub
caps
Requirements:
R
The vehicle is prepared for a wheel change
(
/
page 328).
Plastic hub cap
#
To remove: turn the center cover of the hub
cap counter-clockwise and remove the hub
cap.
#
To install: make sure that the center cover
of the hub cap is turned counter-clockwise.
#
Position the hub cap and turn the center
cover clockwise until the hub cap engages
physically and audibly.
Aluminum hub cap
#
To remove: position center cap 2 from the
tire-change tool kit on hub cap 1 .
#
Position wheel wrench 3 on center cap 2 .
#
Using wheel wrench 3 , turn hub cap 1
counter-clockwise and remove it.
#
To install: follow the instructions above in
reverse order.
% Specified tightening torque: 20 lb-ft
(27 Nm).
Raising the vehicle when changing a wheel
Requirements:
R
There are no persons in the vehicle.
R
The vehicle has been prepared for a wheel
change (
/
page 328).
R
The wheel trims and hub caps have been
removed (
/
page 329).
Important notes on using the jack:
R
Use only a vehicle-specific jack that has
been approved by Mercedes-Benz to raise
the vehicle.
R
The jack is only designed for raising and
holding the vehicle for a short time while a
wheel is being changed and not for mainte‐
nance work under the vehicle.
R
The jack must be placed on a firm, flat and
non-slip surface. If necessary, use a large,
flat, load-bearing, non-slip underlay.
R
The foot of the jack must be positioned verti‐
cally under the jack support point.
Wheels and tires 329