Changing the bulbs
247
i
Due to the location of the bulbs in the
front headlamps, it is best to have these
changed at a qualified specialist workshop,
e.g. a Mercedes-Benz Service Centre.
i
Have the headlamp setting checked reg-
ularly at a qualified specialist workshop,
e.g. a Mercedes-Benz Service Centre.
Changing the front bulbs
Opening/closing the cover in the front
wheel arch
X
To open: turn the front wheels inwards.
X
Unscrew retaining screw
1
.
X
Fold the cover down.
X
To close: fold the cover upwards.
X
Screw in retaining screw
1
.
Removing/fitting the washer fluid res-
ervoir
You must remove the washer fluid reservoir
from the engine compartment before you can
replace the bulbs in the front left-hand head-
lamp.
X
To remove: turn retaining screw
1
anti-
clockwise.
X
Remove washer fluid reservoir
2
from
bracket
3
.
X
Put washer fluid reservoir
2
to one side
and leave the lines and hoses connected.
Make sure that no washer fluid escapes.
X
To fit: guide the lower retaining lug into the
rubber grommet on the longitudinal mem-
ber and fit washer fluid reservoir
2
into
bracket
3
.
X
Turn retaining screw
1
clockwise.
Replacing the bulbs in the dipped-beam
headlamp (halogen headlamps)
X
Switch off the lights.
X
Open the cover in the front wheel arch
(
Y
page 247).
X
Open the bonnet.
X
Left-hand headlamps: remove the washer
fluid reservoir (
Y
page 247).
X
Press retaining lug
:
down and remove
housing cover
2
.
X
Pull connector
=
from bulb holder
4
.
Practical advice
169_AKB; 2; 4, en-GB
wdomann,
Version: 2.10.6
2008-07-16T08:52:06+02:00 - Seite 247
Z
Dateiname: 6515_0315_02_buchblock.pdf;
preflight